2018-20 Jeep Wrangler JL, Unlimited Dana 30 Front CV Driveshaft
$599.95
Product No
5090-1A-HK
FREE SHIPPING Lower 48 States
Important Notes
* An aftermarket driveshaft is HIGHLY RECOMMENDED for installation of any Jeep JL lift kit 3.5” or taller. The factory driveshaft will become damaged if the suspension reaches full droop or flex.
* ONLY fits Dana 30 front axle models.
* Does NOT fit Rubicon models.
* ONLY fits Dana 30 front axle models.
* Does NOT fit Rubicon models.
Quick Overview
When you lift your Jeep Wrangler JL or Unlimited 3.5" or more, damage can occur to the front driveshaft if the suspension is flexed to full droop. The Rough Country front CV driveshaft is the solution to avoid this potential damage. This driveshaft is designed to promote proper geometry in all street driving and off-road scenarios.
View lift kit installation instructions
- Collapsed Measurement: 36-3/8 inches
- Extended Measurement: 39-1/2 inches
- Eliminates facotry driveshaft damage at full droop
- Works on Dana 30 axles ONLY
- Includes better quality CV joints.
- Shaft strength is twice as strong as the factory equipped drive shaft.
- Grease fittings are out of the way of the transmission oil pan meaning you get grease to the joints that need it and not all over the bottom of your Jeep.
View lift kit installation instructions
- Make: Jeep
- Model: Wrangler JL
- Vehicle: 2018-20 Wrangler JL, Unlimited Dana 30 Front CV Driveshaft
- Initialize: 1