2018-20 Jeep Wrangler JL, Unlimited Rubicon, 2020 Gladiator JT Dana 44 Front CV Driveshaft
$599.95
Product No
5093-1-HK
FREE SHIPPING Lower 48 States
Important Notes
* An aftermarket driveshaft is HIGHLY RECOMMENDED for installation of any Jeep JL or Gladiator JT lift kit 3.5” or taller. The factory driveshaft will become damaged if the suspension reaches full droop or flex.
* ONLY fits Dana 44 front axle models.
* Only fits Wrangler JL Rubicon models.
* Fits JT Gladiator Rubicon and Non-Rubicon Models
* ONLY fits Dana 44 front axle models.
* Only fits Wrangler JL Rubicon models.
* Fits JT Gladiator Rubicon and Non-Rubicon Models
Quick Overview
When you lift your Jeep Wrangler JT, Unlimited and Gladiator JT 3.5" or more, damage can occur to the front driveshaft if the suspension is flexed to full droop. The Rough Country front CV driveshaft is the solution to avoid this potential damage. This driveshaft is designed to promote proper geometry in all street driving and off-road scenarios.
View installation instructions
- Collapsed Measurement: 36-3/8 inches
- Extended Measurement: 39-1/2 inches
- Eliminates factory driveshaft damage at full droop
- Works on Dana 44 axles ONLY
- Includes better quality CV joints.
- Shaft strength is twice as strong as the factory equipped drive shaft.
- Grease fittings are out of the way of the transmission oil pan meaning you get grease to the joints that need it and not all over the bottom of your Jeep.
View installation instructions
- Make: Jeep
- Model: Wrangler JL
- Vehicle: 2018-20 Wrangler JL, Unlimited Rubicon Dana 30 Front CV Driveshaft
- Initialize: 1
- Make: Jeep
- Model: Gladiator JT
- Vehicle: 2018-20 Gladiator JT Dana 30 Front CV Driveshaft
- Initialize: 1
- Record Id: 1